Looks good what did you make it out of. When I made mine I used a 5/8" thick rubber horse stall mat. Its heavy and won't blow away while trailering ,plus its easy to clean, dampens the sound as well as gives some sort of protection from anything coming up through the floor.
The 5/8 in rubber stall mat works fine for a bed mat on my P4 as well. Will be using the rest to make floor mats that not only cover the floor, but run up to the edge of the seat as well. Should dampen noise inside as well.
Finished the floor mats today. Did not go uo the edge of the seat. Have not come up with a way to hold it in place. May use what is left over to make rear mats when the blisters heal.
Finished the floor mats today. Did not go uo the edge of the seat. Have not come up with a way to hold it in place. May use what is left over to make rear mats when the blisters heal.
Last edited:
OEM. It locks into place. Will not blow out while trailering. I've trailered my P4 over 85mph and it's stayed in.
Thanks I made my own cargo mat and had left over and since had front mat decided to make some rears.
Code54
Well-Known Member
Lifetime Member
Club Contributor
The stall mats at Tractor Supply work very well and for about $40 you can do the front and back. I also used one to make a mat for the bed of my FXT and noticed that it cut the noise down a little bit (nice bonus)
