P700 700 front axles problems!!!

[Robologger]

Anyone have issues with front axles on. 700-4 I have a three inch lift and outlaw2 seems axles are o er extending and coming apart. Am I the only one?

 

[Robologger]

This is her

 

[motorman18]

Iv broke a few axels with less lift then what you have 3 inch is probably pushing it to the limit but aftermarket axle will handle it better

 

[motorman18]

How well does it turn them outlaws

 

[Robologger]

It does good until u get in really think stuff but normals it will back out of it if it won’t go through it. What type of aftermarket axles do u recommend ?

 

[Robologger]

14-16 Honda SXS 700 M2 M4 Pioneer 700 ArmorTech HD Front Right Axle Stock Length Anyone heard of these axles are they any good?

 

[motorman18]

Haven’t heard of that axel I’m not running aftermarket yet if I break another I’ll probably get a rhino axel

 

[SundayRdr]

I'm running SuperAtv Rhino axles and they're better than stock. They are about 1/2" longer, thicker shafts, better boots

 

[Robologger]

I'm running SuperAtv Rhino axles and they're better than stock. They are about 1/2" longer, thicker shafts, better boots

How much lift do u have on it?

 

[SundayRdr]

CanAm Commander shocks so 2-2.5.

 

[Billjones617]

Gotta remember OP, factory axles were meant for factory spec'd tires.

If you start changing things, get ready to go aftermarket on the drive train as well.

 

[SundayRdr]

@Robologger the rhino axles clame 30% more articulation too.

 

[Gator]

I'm running about 5" of lift and so far I haven't broken an axle. I'm sure I will eventually.

 

[Robologger]

Mine would only break when I turned all the way after front shocks were fully extended. I just took the bracket portion of my lift off and left the spacer In The shock I am hopeful I still have enough clearance without over extension of the axles which is what I believe was causing them to break. I lost one inch of clearance but I am still sitting at 14 inch’s in the front. I will post a update after I test it out

 

[scott]

I’ve had my 700-4 for 4 years now. Haven’t broken a single axle. I ride hard and push it. 27” bear claw HTR and Can Am commander shocks.


Sent from my iPhone using Tapatalk

 

[ohanacreek]

I’ve had my 700-4 for 4 years now. Haven’t broken a single axle. I ride hard and push it. 27” bear claw HTR and Can Am commander shocks.


Sent from my iPhone using Tapatalk

If it can stand up to @scott,....THATS when it’s considered “trail rated”.

He rides HARD but he doesn’t ride to trash the machine.

 

[Cyberjunk]

I’ve had my 700-4 for 4 years now. Haven’t broken a single axle. I ride hard and push it. 27” bear claw HTR and Can Am commander shocks.


Sent from my iPhone using Tapatalk

Ok so basically I have the same , 27 inch blackwaters and can am shocks, broke both stock front axles and now 3 all balls ? and I drive like a grandma on her way to Sunday brunch with a cake in my lap

 

[Matt99gators]

Anyone have issues with front axles on. 700-4 I have a three inch lift and outlaw2 seems axles are o er extending and coming apart. Am I the only one?

I have 2017 700 with no lift and 27s. My passenger side front axle is pulling out of the Diff. Dont know how or why this is happening. Tapped it back in and looks fine. Wanting to fix permantly,

 

[motorman18]

Pull it all way out I bet the ring not on the end to hold it in

 

[Matt99gators]

I wasn't aware of any retaining ring holding the axle in..... (Inside the front diff?)