P1000 Full length hard doors

[IdahoSxS]

I have the Honda hard doors too. I have a 1/4" gap along the front of the door and roll bar. When it is eating hard, a lot of water comes in. Have you had a similar problem?

I have a Honda Pioneer 1000P3 with the Honda OEM glass windshield, hard back, hard top and hard doors, hinged along back edge. I too had a 1/4" gap along the front roll bar. You can nearly eliminate the gap by loosening the hinge point screws and adjusting the latch position in front. It takes some back and forth and helps to have someone helping lift the door while the hinge screws are tightened. Be patient, again, it takes a lot of trial and error.

 

[IdahoSxS]

Sometimes the dealer you buy your vehicle with will give you a break on the doors and other accessories.

 

[Buckslayr]

Mine is sealed good on front of door,after the storm if you want,I can send pictures

 

[IdahoSxS]

What rear window are you running? You have the exact setup I’m looking for. I want to enclose the front seat and leave the rear open so i can use the bed.


Sent from my iPhone using Tapatalk

I have heard that if you have a full windshield and leave the back open, dust will roll in. I may be wrong.

 

[Buckslayr]

I have the Honda hard doors too. I have a 1/4" gap along the front of the door and roll bar. When it is eating hard, a lot of water comes in. Have you had a similar problem?

No mine seal pretty good

 

[Buckslayr]

No mine seal pretty good

View attachment 312306 View attachment 312307

 

[MaconMan12]

i have the Honda hard doors,I really like them,I had to make a mounting bracket for my seizmik mirrirs, but, they fit nice, now they have them in 2 colors, they would be even better.

View attachment 228581 View attachment 228582 View attachment 228583 View attachment 228584

What colors do they come in now?