P1000m5 Looking for stock front A arms

[Dave46140]

Drove my tracked rig through the ice on my lake and bent stock arms on drivers side in the process. Looking for replacements, both upper and lower, drivers side but will consider taking both sides, maybe leftovers from a lift kit install, thanks

 

[Admin]

 

[Vikes79]

Drove my tracked rig through the ice on my lake and bent stock arms on drivers side in the process. Looking for replacements, both upper and lower, drivers side but will consider taking both sides, maybe leftovers from a lift kit install, thanks

@JenElio may be able to hook you up!

 

[Dave46140]

@JenElio may be able to hook you up!

Just reached out, thanks for the reference

 

[Gabbas]

Also might want to check to make sure you didn't bend the tabs that mount the A-arms. They are a weak point.

Sent from my Pixel 4 using Tapatalk

 

[Dave46140]

Also might want to check to make sure you didn't bend the tabs that mount the A-arms. They are a weak point.

Sent from my Pixel 4 using Tapatalk

Thanks, will check them out

 

[rickoshea]

i was ripping down the lake last winter and hit a deadhead sticking out of the ice.luckily i only broke my track a arm lower mount on the passenger side.tough break bud.

 

[Smitty335]

Drove my tracked rig through the ice on my lake and bent stock arms on drivers side in the process. Looking for replacements, both upper and lower, drivers side but will consider taking both sides, maybe leftovers from a lift kit install, thanks

Check with @Neohio, I gave him my full set of stocks

 

[Russ989]

I have a full set but I bet the shipping would be awfully high.

 

[Dave46140]

i was ripping down the lake last winter and hit a deadhead sticking out of the ice.luckily i only broke my track a arm lower mount on the passenger side.tough break bud.

Thanks Rick

 

[Dave46140]

Also might want to check to make sure you didn't bend the tabs that mount the A-arms. They are a weak point.

Sent from my Pixel 4 using Tapatalk

Thanks again for the tip. The upper a arm mount get pulled away from the tubing. Looks like the weld was incomplete, lacked penetration across its entire length. Must bend it back and weld it up. Found a kit with support/skid plate with lower mount brackets I’m going to add. Really disappointed with quality of the frame.