P500 Parts question and beer.

[RichUSAF]

Beer. Ok got your attention .

Went for ride today in the rain. Put my fabric doors on (for the first time) to get ready for winter and I noticed a strap at the top of the door. I can not figure out what it is for. I attached it to the roll cage but it didn’t do anything. Any one know what it is for?

2). Anyone know what part to order for the weatherstrip for side of wind shield and what part is the tension clamp?

 

[Admin]

 

[dls1966]

I think the strap is too close the door once you get inside

 

[Chooglin]

You can get the rubber side seal hear , they sell it by the foot

Side bulb Push-On Seal

 

[dls1966]

I would say to go to the Honda shop for the tension clamp for your windshield they would have a schematic

 

[Hondasxs]

OH.. I have the part #'s. Standby.

 

[Hondasxs]

You just reminded me a old friend sent me these long ago. He asked I not share them. But he's no longer with Honda so.... Here you go.
FYI, these are dated 2016. Your dealer should have a "service parts listing". Same as this.

I noticed the "t" bolt is not listed as fitting the 500? When did the split windshield come out for the 500? After 2016? High possibility it's the same part.
I'll put some part #'s in text here in a few with links.

 

[Bastardchild]

As for the knob thing that you're missing you can probably go to Lowes, Home Depot, Rural King or Northern Tools and go to the hardware section where they have the pull out drawers full of odds and ends hardware. They have threaded studs with the plastic thumb wheels molded on the ends. Just take your threaded thumbwheel from the other side of your windshield with you to match up the thread pitch on the new one. I understand you probably want o.e.m. though.

 

[RichUSAF]

Honda got me hooked up with a T handle that tightens down, works like a charm and have that weather strip on way that was recommended above. Thanks Everyone!