T
I decided to add the Honda bedliner. I found one on Ebay for $400 shipped. We have a lot of new landscaping coming up at the new house and feel it will be worth it to keep crap out of the seat and door areas. It easily removes with 3 screws.
I suppose the warning label area could be used for more switches.....
Added the tailgate leveling brackets from @mystic1219 . These are great brackets. I'm not too fond of the taller versions that are out there. Of course when installing, I discovered that Honda neglected to install one of the 2 bushings on the passenger side so I had to make one.
I found the largest water tank I could at Tractor Supply that would physically fit as well as be near the Pioneers max weight capacity when full. We have A LOT of new trees that will be planted at the house as well as routine ditch burning that I want to be prepared for. I need to build a frame yet that will mount the tank, pump, ect. in the back. Have I mentioned that I miss my welder....
I spent what seemed like forever deciding on a phone mount location. I finally decided on the ROPS above the driver. It's out of the windshield viewing area and shouldn't be affected by the suns glare, and yes, It's out of the way of the rifle when locked for travel or swung down to be deployed.
This, of course, required an additional USB charging port within reach of the cable......
I suppose the warning label area could be used for more switches.....
Added the tailgate leveling brackets from @mystic1219 . These are great brackets. I'm not too fond of the taller versions that are out there. Of course when installing, I discovered that Honda neglected to install one of the 2 bushings on the passenger side so I had to make one.
I found the largest water tank I could at Tractor Supply that would physically fit as well as be near the Pioneers max weight capacity when full. We have A LOT of new trees that will be planted at the house as well as routine ditch burning that I want to be prepared for. I need to build a frame yet that will mount the tank, pump, ect. in the back. Have I mentioned that I miss my welder....
I spent what seemed like forever deciding on a phone mount location. I finally decided on the ROPS above the driver. It's out of the windshield viewing area and shouldn't be affected by the suns glare, and yes, It's out of the way of the rifle when locked for travel or swung down to be deployed.
This, of course, required an additional USB charging port within reach of the cable......
It's been a while since I've been able to do much on the Pioneer. I finally made the Delrin mounting plates for the Rough Country rock lights I bought to use as dome lights and cargo lights. The two front lights are mounted on the upper angled portion of the ROPS, just behind our heads. I machined a radius in the back of the pad to match the bar diameter and basically glued it to the bar with Permatex Ultra Black. The cargo lights are slightly angled and attached to the roof with 3M tape. Had to clean the crap out of the roof to get the mold release or whatever the heck was on it, off, in order to feel good about the adhesion. These things are quite bright, and do an excellent job!
Similar threads
P1000
Chunk’s Bus Build
- MeigsP1000-6
- Pioneer 1000 Builds 2
