Major General 2024 Talon 1000R-4 Build Thread

[Coeus]

Here is the other side that has the Rokblokz installed

 

[Admin]

 

[JenElio]

Here is the other side that has the Rokblokz installed

View attachment 429160

🤨 You need more fishing rods......😂😂😂

 

[Coeus]

🤨 You need more fishing rods......😂😂😂

Troof

 

[Buggyman]

Here is the other side that has the Rokblokz installed

View attachment 429159View attachment 429160

That looks good. you are making good progress on the box pile. 👍

 

[Coeus]

I know it's a little hard to see on mine, but it runs inside the ROPs then up into the cab:

View attachment 429201

Do you like the whips in that location? I’m sure you had them mounted in other locations as well… (nomo)

trying to decide where mine should go as well (bought 3’ ones so they shouldn’t stick up too much if mounted vertically on the lower ROPS)

 

[Adam490]

Do you like the whips in that location? I’m sure you had them mounted in other locations as well… (nomo)

trying to decide where mine should go as well (bought 3’ ones so they shouldn’t stick up too much if mounted vertically on the lower ROPS)

Yeah, that’s the most vertical I can get them and still fit it in my garage. I had them mounted along the ROPS but they got beat to s*** by the bar and filled up with water.

 

[Coeus]

Working with Ian at Crossroads 3D has been awesome! Big shoutout to him... he responds to emails, refunded the shipping amount when it was actually cheaper, and provides great guidance!

 

[futzin]

Working with Ian at Crossroads 3D has been awesome! Big shoutout to him... he responds to emails, refunded the shipping amount when it was actually cheaper, and provides great guidance!

3 sets cup holders
2 glove boxes
1 phone holder
All good, recommend.

 

[906UP]

I used him for the Auxbeam mounts in 2 Talons, good stuff

 

[Scoop]

Yeah, that’s the most vertical I can get them and still fit it in my garage. I had them mounted along the ROPS but they got beat to s*** by the bar and filled up with water.

I have mine mounted upside down along the ROPS. Mounts are at the top. I used 321 Stainless Steel 2" ID Snug-Fit Vibration Damping Loop Clamps w/Neoprene rubber cushions from McMaster-Carr at bottom to keep them from moving. So far, everything has stayed in place, and I have had no water in them (not sure if I added any sealant or not).

 

[Scoop]

Working with Ian at Crossroads 3D has been awesome! Big shoutout to him... he responds to emails, refunded the shipping amount when it was actually cheaper, and provides great guidance!

100% agree. I'm a repeat customer.

From a customer service and comms standpoint, both Ian @ Crossroads3D and Brian (@highpocket74) @ 10-80 Dirt Sports are the best!

I had some PVM controllers shipped from Amazon to him. He modified an existing over the bar 6-gang box design to support my controllers for the fans I installed in the roof of my Talon. An absolute pleasure to work with.

I used him for the Auxbeam mounts in 2 Talons, good stuff

Me, too. We actually worked together to improve the Auxbeam mount design for the '22+ Talons last year (not sure when you ordered yours).