P700 I have a 2016 Pioneer 700-2 I am putting new tires, and wheels on the rear, help

[roadturtle59]

I HAVE 2016 Pioneer 700-2 I am putting on the rear
Maxxis Bighorn 2.0 Tire - 25/12R12 will these wheels fit and work ok,
ITP Delta Steel Wheel - 12x7 - 4+3 Offset - 4/110 - Black , Bolt Pattern: 4/110, Rim Offset: 4+3, and will I need new lugs? Thank You

 

[Admin]

 

[joeymt33]

Are you only replacing the rear tires?

What size are the front tires?

I ask these questions because the Bighorn true size may be different than the true size of the front. I'm sure a small difference won't hurt anything unless you drive fast in 4x4 on pavement.

If you're concerned about the 12" width, it will be ok.

 

[roadturtle59]

Are you only replacing the rear tires?

What size are the front tires?

I ask these questions because the Bighorn true size may be different than the true size of the front. I'm sure a small difference won't hurt anything unless you drive fast in 4x4 on pavement.

If you're concerned about the 12" width, it will be ok.

No, I am using
ITP Delta Steel Wheel - 12x7 - 5+2 Offset - 4/110 - Black , Bolt Pattern: 4/110, Rim Offset: 5+2,
Maxxis MU09 Bighorn 2.0 Tire - Front - 26x9Rx12 , Position: Front, Rim Size: 12, in the front, thank you

 

[roadturtle59]

No, I am using
ITP Delta Steel Wheel - 12x7 - 5+2 Offset - 4/110 - Black , Bolt Pattern: 4/110, Rim Offset: 5+2,
Maxxis MU09 Bighorn 2.0 Tire - Front - 26x9Rx12 , Position: Front, Rim Size: 12, in the front, thank you

I spend about 50/50 % of my time in sand, and hard dirt/rock =)

 

[joeymt33]

You'll be fine with that size. I ran 10" wide in the front and had no problems.

If you're curious, 27" tires will fit with no lift and no rubbing.

 

[roadturtle59]

You'll be fine with that size. I ran 10" wide in the front and had no problems.

If you're curious, 27" tires will fit with no lift and no rubbing.

I consider those, however I was concerned about torque loss from going from a 25 to a 27. The group I ride with out here in S. Utah have switched over to these tires and they are awesome. Thanks again

 

[joeymt33]

I am doing a lot of upgrades the next two weeks. Younger folks would do this in a day or two. Since I am a senior citizen it will take me a little longer, lol.
I have another question. How do I raise the speed limiter from 43 to 55?

I'm not sure you can. The motor is screaming already to run 43.

It would take different hearing in my opinion. I'm not real sure the 700 has enough power to push thru the air at 55??

Maybe someone else will come along with some more info.

 

[bigc]

make sure the delta wheels have 12mm bolt holes cause most of them have 10mm for atvs

 

[roadturtle59]

No, I am using
ITP Delta Steel Wheel - 12x7 - 5+2 Offset - 4/110 - Black , Bolt Pattern: 4/110, Rim Offset: 5+2,
Maxxis MU09 Bighorn 2.0 Tire - Front - 26x9Rx12 , Position: Front, Rim Size: 12, in the front, thank you

Error; I am using ITP Delta Steel Wheel - 12x7 - 4+3 Offset - 4/110 - Black , Bolt Pattern: 4/110, Rim Offset: 4+3, on all 4 wheels.

 

[roadturtle59]

I spend about 50/50 % of my time in sand, and hard dirt/rock =)

error; I am using on all 4 tires ITP Delta Steel Wheel - 12x7 - 4+3 Offset - 4/110 - Black , Bolt Pattern: 4/110, Rim Offset: 4+3

 

[roadturtle59]

I spend about 50/50 % of my time in sand, and hard dirt/rock =)

Error; I am using ITP Delta Steel Wheel - 12x7 - 4+3 Offset - 4/110 - Black , Bolt Pattern: 4/110, Rim Offset: 4+3, on all four wheels