My homemade roof

[tzink]

Here's my home made roof,
3/8" abs plastic.(needed 2 4x8 sheets, with lots of waste.)
Some pipe clamps
Stainless hardware
Alum H channel

Put the sheet in my buddies brake, and heated it with 3 heat guns at once, until it would bend, in order to bend the front visor. The rear corners were heated and bent by hand.

Total cost $125. And very little work reallyView attachment 43589View attachment 43590View attachment 43591View attachment 43592

Where did you get the ABS for so cheap?

 

[Admin]

 

[Eam22357]

I did the same thing !

 

[2019Pioneer700-4]

Where did you get the 3/8 plastic sheets from?

 

[toddvdh]

Prices were way lower in 2017

 

[bumperm]

Prices were way lower in 2017

And we ain't seen the worst of it . . .

 

[Ronbow411]

love it need one for a 1000-3

 

[Kal]

Where did you get the 3/8 plastic sheets from?

Someone told me that a home improvement store called menards has it, I just don't have a menards here because I live in the western half of the country. They call it HDPE board, or something like that...

 

[Bored808]

Hello, I know this is an old post but I love what you did!
What type of pipe clamps did you use? Do you have a link?
sorry, not new to dirt, just new to Sxs

 

[Remington]

Hello, I know this is an old post but I love what you did!
What type of pipe clamps did you use? Do you have a link?
sorry, not new to dirt, just new to Sxs

You are correct, its an old post. But more importantly the OP, assuming thats who your responding to cuz you didnt tagg him or the part in question in your post, hasnt been on the site in 3 years.
I would either send him a PM (he might get an email and respond)
Use the search for your question or start a New thread for your question.

 

[DRZRon1]

suggestion - just search cushion clamps, measure rops diameter and order up appropriate size