P500 vid of short ride down to the lake

[jak9922]

 

[Admin]

 

[Montecresto]

Nice video. I notice you shift back and forth between 2 and 4 wheel drive on the fly!! That doesn't cause damage as the warning label seems to indicate?? Also, is that a four position rocker switch assembly on the dash?

 

[joeymt33]

Haha, glad your passenger had a helmet. That limb popped him pretty good.

 

[sthomp54]

Looks like an awesome place to ride, where is it? Thanks for the video.

 

[jak9922]

big lake down the road from my house that only the half way point but to many down trees now ill have spring clean up to do lol

 

[jak9922]

yes I change 2-4-2 on the fly under no throttle and only in L-2 gear and those are 3 rockers and 1 usb charger on my dash

 

[jak9922]

Haha, glad your passenger had a helmet. That limb popped him pretty good.

that's my son lol hes always with me

 

[Shadesmn]

yes I change 2-4-2 on the fly under no throttle and only in L-2 gear and those are 3 rockers and 1 usb charger on my dash

How do you have those switches mounted? Can you post a closer pic?

 

[jak9922]

Amazon.com: Rugged Ridge 17235.20 Black Rocker Switch Housing Kit: Automotive
then trace out on your dash carefully cut and pop in lol easy peezy just remember cut small first then trim u can always take more off but cant put it back

 

[Montecresto]

Amazon.com: Rugged Ridge 17235.20 Black Rocker Switch Housing Kit: Automotive
then trace out on your dash carefully cut and pop in lol easy peezy just remember cut small first then trim u can always take more off but cant put it back

Exactly, use a Dremel not a Skil saw right? what's the difference between the cut out and what the housing frame covers, an 1/8 th. inch??? Say, just checked out your link, it shows four single box housings, you didn't use a single quad box?

 

[jak9922]

I just trace it out then cut inside the lines

 

[Montecresto]

I just trace it out then cut inside the lines

Ok......I asked a few questions in that post. Can you elaborate some?

 

[jak9922]

On that link i sent u snap the switch brackets however many u want 2-3-4 once they are together place the back of the bracket up against your dash abd trace around the outside with a sharpie then gut it out with a dremel once done and its nice and tight push the bracket in it has little friction clips built in that hold it in place but u can always add a little silicon for added insurance

 

[Montecresto]

On that link i sent u snap the switch brackets however many u want 2-3-4 once they are together place the back of the bracket up against your dash abd trace around the outside with a sharpie then gut it out with a dremel once done and its nice and tight push the bracket in it has little friction clips built in that hold it in place but u can always add a little silicon for added insurance

Thank you!

 

[jak9922]

No prob