P1000 500s Build

[500]

Might as well start one as the accessories are going to start rolling in over the summer.
-Honda OEM roof
- @Bayouownbeer heat shield
-Brush guard mounted 10" LED
-Rearview mirror
-StrongMade 2" lift
-Factory UTV A Arm guards
-(2) Hood mounted side cube 4" LED's

 

[Admin]

 

[500]

 

[Delton]

And so it officially begins lol. Nice start too. The rearview is one of my favorite mods.

 

[500]

 

[500]

No diff in ride which is what I expected with a lower mount kit that keeps coil over angle the same or near OEM.
Now I need to decide on wheels/tires. Leaning towards 28x10-12 EVO's on all 4 corners with 5+2 offset 12" wheels.

 

[500]

@JACKAL how much thread did you have exposed once you torqued the nut back on the sway bar?

 

[500]

Factory UTV A Arm Guards.

 

[500]

Hood mounted side cubes.

 

[500]

Spectre 3" to 2.5" coupling (Autozone)
Spectre 3" 90 pipe (Autozone)
Standard hose clamps for 3" piping
Retained the pre-filter, hood support, and relay cover. Cut out center portion where coupler and 90 are located.
Used a rubber gasket to slip over the end of the 3" 90 pipe so that I could run screws through it into the pre-filter to keep it vacuum resistant.

 

[sharp]

View attachment 20531

Post a parts list when you get a chance

 

[500]

Post a parts list when you get a chance

Done. Edited post.