If anyone has the P1K bearing greaser it will work on the Talon as well, you just have to remove the axle.
The rear is super easy, just remove the two outer radius rod nuts and swing the axle out.
You should post us a part number
It would be nice to know the inside diameter of the bearing and axle size to see if the bearing greasers from my RZR would work. One is 44mm and I can't remember the other size. Had two buy both sizes for my 800/4 since it has different sizes front to back.
Honda does list the bearing size in the part description. It is a standard bearing (Front and Rear are the same)...Honda doesn't list size but from what I can find the inner diameter of the bearing is 40mm.
Honda does list the bearing size in the part description. It is a standard bearing (Front and Rear are the same)...
BEARING, ANGULAR BALL (40X74X36) 91054-HL3-A41
40mm inner, 74mm outer, 36mm wide.
This means you can use any brand/manufacturer you desire if your factory bearings fail.
Good I have a 40mm for RZR, now if the center and the depth are the same.Honda doesn't list size but from what I can find the inner diameter of the bearing is 40mm.