P700 Full Fabric Cover/Rear Window Gap

[Lynn1130]

I have not seen a threat concerning this issue so I hope that someone may have an answer to my problem.

I have the full fabric top and the rear clear fabric window but there is a gap at the top between the window and the top that allows dust to enter the rear seat area. Short of using Gorilla Tape and closing that off I am not sure how to close that gap. If someone has done this or has some ideas I would love to hear them.

 

[swsebek]

I'm thinking they mounted it to low on tailgate
That's if you have a p4

 

[Lynn1130]

Nope. It only mounts one way with the top snapping around the top roll bar and I put the bungee loops exactly where the instructions show. It is a P4

 

[swsebek]

My bungees were connected to 2 spots I had to drill and put on my self...
Anyway can you just shift the soft top back some. Loosen front
Remove side straps and pull back of roof down some.

 

[Lynn1130]

I too had to mount the bungee posts. But what I should have mentioned is that I have the windshield and the top mounts to the windshield with two bolts drilled through the top of the windshield and the front of the cover. Nothing is going to move much forward or back.

 

[swsebek]

Ok your rear is different that mine.
My window is smaller and I bought the Honda rear panal.
Gorilla tape would work for a while but would come off and look like hell.
Yes I too put snaps on my windshield and can't slide either
I'm just thinking of spray painting a funoodle or get some pipe insulation and use it on the in side.You could glue or tape to ROPS and fill that gap. If it's black it won't be noticeable

 

[Lynn1130]

What "pipe insulation"?

 

[swsebek]

It looks like this

 

[Lynn1130]

OK. Thanks. That is what I thought. The other thing I am researching is a "foil" or dust deflector to mount on that bar at the back. I am going to have to modify one if I can find anything. I don't like all the dust on the rear window anyway.

 

[swsebek]

Take them off together and have a piece sewn in