P1000 Homemade snorkel

[Trackerone]

I just bought a 1000-5 deluxe and I would line to snorkel it as an insurance policy but for what it takes I can see paying high lifter $200 for the kit, anyone got pics of their homemade to give me idea on how to runs it so it doesn’t look too bad?

 

[ToddACimer]

Here's what I have.

 

[Penrod]

I routed mine through the passenger side cup holder hole. All 2" SCH40 PVC.

5 x 45 degree elbows
3 x 90 degree elbows
1 x silicone adapter
2 x hose clamps
and a 10' piece of 2" PVC should do it.

 

[T-County]

Here's what I have.

View attachment 198407

 

[T-County]

Does the sock cover restrict air flow. I stuffed the snorkel with the hard course that the intake. does good until I open her up. then it bogs the motor down

 

[pct]

I made one that came out behind the seat but you have to take the center seat belt retractor out it is in this section under yet another snorkel I think hope this helps
Paul

 

[ToddACimer]

Does the sock cover restrict air flow. I stuffed the snorkel with the hard course that the intake. does good until I open her up. then it bogs the motor down

There's no difference with or without the Uni prefilter. It does keep the stock filter a lot cleaner

 

[T-County]

where did you get it from?

 

[ToddACimer]

where did you get it from?

eBay

Universal Fit Ram Inlet Intake Snorkel Head 3.5" Inner Diameter Off Road 4x4 New | eBay

Fit Most Snorkel With 3.5" Inlet Piping. This item will fit the following model .

www.ebay.com

 

[T-County]

thanks

 

[Chevy412SP]

Here's what I have.

View attachment 198407

Where did you get the 90 elbow and the rest of the fittings you used for your snorkel?

 

[ToddACimer]

Where did you get the 90 elbow and the rest of the fittings you used for your snorkel?

Here's the parts list from my build thread

P1000 - Todd's 2018 Build

The tabs will go on the back side of the harness bar. I could just weld them to the harness bar but then I can't change it later as easily. Until I get the bar I won't know for sure Bed won’t dump then

hondasxs.com

 

[Chevy412SP]

Thank you very much sir👍

 

[nitzo]

I followed what @ToddACimer did.:

 

[JsheII3]

 

[kamikaze]

Quick, easy and cheap! Figured the middle is the best location for a snorkel since you usually End up sideways is a Deep mud hole.

 

[Ridinfool]

this is my setup, 1: 2 3/4” to 3” silicone adapter 1: 3” piece of pipe from a cold air intake and 1: 90 deg snorkel top.

 

[SuperMidget]

$27 and she's save up to the back of the seat

 

[JenElio]

$27 and she's save up to the back of the seat

View attachment 217980 View attachment 217981

How much louder is that being right behing the seat?

 

[SuperMidget]

can have a normal voice conversation unless she is full throttle in a mud hole.