Anyone seen a blank, protective cover for the PO bases for when nekkid? The tabs seem a bit vulnerable to me.
NTCPrezJB
President of #NTC
Lifetime Member
Supporting Member
I bet @-Bear- could make one in a hurry!
-Bear-
NTC Master Fabricator
Lifetime Member
But then I'd never want to take it off!
It would be nice to have a blank cover to protect the PO base plates for when you wanna run without boxes.
Something that snaps in like the boxes, but doesn't cover the metal rods used for attaching bungees or whatever.
Only thing close that I saw was on Etsy, and not really what I was after. Anyone seen anything?
@-Bear-
@monaco
Something that snaps in like the boxes, but doesn't cover the metal rods used for attaching bungees or whatever.
Only thing close that I saw was on Etsy, and not really what I was after. Anyone seen anything?
@-Bear-
@monaco
Last edited:
I bought some pack out “feet” off Amazon. I plan to make a plywood cover with router edges to go on when flat surface is needed. Just hasn’t bubbled to the top of my to do list
906UP
Well-Known Member
Lifetime Member
Supporting Member
Club Contributor
