P500 new 700 aluminum wheels

[luger1]

does any one know if the new 700 aluminum wheels will fit on a 500 and if so is the offset the same I would like to install these wheels but I also need to keep the machine 50 inches wide the part #s for the steel wheels are the same for the 500 and the 700

 

[Admin]

 

[HUCK]

JUST DO IT

 

[rocmar]

My guess would be...
If you wanna stay 50"
.....stay stock

 

[Montecresto]

does any one know if the new 700 aluminum wheels will fit on a 500 and if so is the offset the same I would like to install these wheels but I also need to keep the machine 50 inches wide the part #s for the steel wheels are the same for the 500 and the 700

I've been through this exercise repeatedly, I still can't find an AM wheel without an offset. But if you should happen to, please post it here. Thanks

 

[Buford]

does any one know if the new 700 aluminum wheels will fit on a 500 and if so is the offset the same I would like to install these wheels but I also need to keep the machine 50 inches wide the part #s for the steel wheels are the same for the 500 and the 700

I'm sure the aluminum wheels will be a direct bolt on. Should be no reason for them to be a different width or offset than the steel wheels.