P1000 P1000 rod bearing sizing chart

[helander14312]

i am looking for any information on rod bearing sizing on a p1000. i took in a "basket case" and someone removed the bearings from the engine. My guess is that they water logged them and they spun. The crank looks good and appears to need just a light polish. any help is much appreciated. I am going to micrometer it out once it is polished but dont want to order 400$ in bearings if i can help it.

 

[Mark in Northern Iowa]

Howdy and welcome from Northern Iowa
.
You never said what year.
2016-2020 Honda Pioneer 1000 Service Manual
looks to be around page 15-8
.
Somewhere on here you can find the manual.
If you are that deep into it, you need the manual anyway.
.
Have a good day

 

[helander14312]

2016

 

[helander14312]

both rod caps are stamped b with II in roman numerals on the caps and rods

 

[Remington]

2016

Pics Or It Didnt Happen!

 

[Mark in Northern Iowa]

Upgrade your membership and then you have access to the Service Manuals.
.

Upgraded to “Lifetime Membership”

Like this site and the peeps so much I thought it was time.

hondasxs.com

.
AND all the SHI...........Stuff you can handle. haha!!
.
Have a good day

 

[helander14312]

Well, I guess here is your proof....

 

[DRZRon1]

Well, I guess here is your proof....

View attachment 410450 View attachment 410451 View attachment 410452

hi - the bearings are labeled from Honda on the their parts schematic A, B, C, D, E for the crank as well as piston rods - no clue what size that means but I am thinking since you have B's now, order up B's and next size larger (C ?)if you think the polish will take some material off...... send back what you don't use

looks like a bearing set (6) for the crank is $55, no tax, no delivery

take all this with a grain of salt as I have never ordered crank bearings for this engine but the B seems to match the honda oem parts

 

[Remington]

Well, I guess here is your proof....

View attachment 410450 View attachment 410451 View attachment 410452

Not that…the whole rig! 🤣

 

[helander14312]

so far, new wiring harness, new PCM, new idle motor, new throttle body sensor, used bed, new front bumper, used airbox, used muffler, used headrests, and one of the groups O2 sensor bypass. It was originally a 5, but someone removed the bed, snorkeled it and made it a mud runner. I am sure that is how the bearings got washed out. probably cranked it over after submerging it.

 

[Remington]

so far, new wiring harness, new PCM, new idle motor, new throttle body sensor, used bed, new front bumper, used airbox, used muffler, used headrests, and one of the groups O2 sensor bypass. It was originally a 5, but someone removed the bed, snorkeled it and made it a mud runner. I am sure that is how the bearings got washed out. probably cranked it over after submerging it.

View attachment 410461 View attachment 410462 View attachment 410463

Thats 16’
Did U or it have the clutch update done? If not, good time to do it while your in there. Sucks to take it apart again!

BTW do t forget to hit “Reply” then type your response. Otherwise the person your responding too wont get a notice that you did.

 

[helander14312]

I will check, I was unaware of this bulletin. Thank you very much for the heads up on this.