P1000 Scoop's 2021 P1K5 Deluxe Phantom Camo Build

[Scoop]

Youngest offspring got me a farm jack this past Father's Day. Ordered the base plate for it. Now I have to figure out where to mount it, which mounts to use, and if this JAH can handle strapping another 34.4# on it ...

 

[Admin]

 

[Scoop]

Mounted the farm jack to the SATV rear tire carrier.



The rear mesh panel (used during the warm months) secures to the ROPS on the top and sides, but the bottom simply overhung the tailgate. I noticed that the snaps for the CEC enclosure fell exactly under and along the bottom edge of the mesh, so I added snaps to the trim on the mesh panel. It now secures to the tailgate.

 

[viperr817]

Spent a couple hours swapping the OEM springs on some new Fox QS3 fronts (3P) and rears (5P) with Viper linear rate springs (F: 250#/R: 300#). Would like to find time tomorrow to get them swapped out on the bike, but it's a busy weekend.

View attachment 352225View attachment 352226View attachment 352227View attachment 352228View attachment 352229

How do u like the ride and height vs stock fox springs? And do you have part numbers of the springs?

 

[Scoop]

How do u like the ride and height vs stock fox springs? And do you have part numbers of the springs?

It worked well for the weight of what we normally carried. Any heavier and you'd want to go stiffer springs.

I cranked up the preload on the Fox QS3 shocks, so it was probably a bit higher than most, but I liked it.

Here's the part descriptions from the Amazon order. I don't think that seller is on Amazon anymore, though.

 

[viperr817]

It worked well for the weight of what we normally carried. Any heavier and you'd want to go stiffer springs.

I cranked up the preload on the Fox QS3 shocks, so it was probably a bit higher than most, but I liked it.

Here's the part descriptions from the Amazon order. I don't think that seller is on Amazon anymore, though.

View attachment 464910

Thanks for the fast response! I went with rear 400# hopefully its not too much.