EMP Rear Bumper P4 Modification
my front bumper was supposed to show today but when I checked the tracking it pushed back to tom. I did however get a chance to do some work on the rear bumper, mounted my new wheels and tires and got the front bumper removed so that when the new one shows tom I can mount it up.
I cut the mounts down to 1.25"
I then welded a piece of angle iron in to reinforce the plate since so much material was lost.
I then painted them up and mounted them.
then re-assembled everything. I the driver side actually has about 3/8" space between the roll bar. the passenger side is touching but it was enough that im pretty positive I have full tilt. I didn't get a reference point prior to mounting the brackets and didn't want to remove them to make sure. looking at hondasxs pics it appears that if I did loose any tilt it was very minimal.
my new tires/wheels 27x9-12's all the way around on itp ss312's
you can tell they aren't the factory tires but they ride pretty good. they measured out to just over 27". I also cranked my rear shocks up I no have a full 12" of clearance in the rear and just slightly more in the front. now I just need to wash it, it would have been nice if it were clean before I started taking stuff apart as I had dirt falling off on me the entire time.
