P1000 Copnhgn’s 2018 1000-3 LE Build

[ToddACimer]

Which winch do you suggest? I think that will most likely be my next purchase?

Superwinch Terra45

 

[Dirtstiffs-1000]

Which winch do you suggest? I think that will most likely be my next purchase?

Motoalliance Viper Elite Widespool 5 or 6k # winch.
Excellent quality and sold by the Hondasxs.com store.

 

[zmnypit]

Get it at Hall's in Trussville?

 

[Copnhgn]

Not a big one, but an important one. Had some time to get my first accessory added last night.

I will be using the pioneer to work with my bee hives, the propolis from the boxes stick to everything and is very difficult if not impossible to remove. So I want to put some kind of mat in the bed.

I ordered a 4’ x 5’ x 1/8” Rubber cal diamond plate sheet rubber. Then just cut it with a utility knife and exacto knife to fit. Needs some time for the rubber to lay down since it was rolled up but fit turned out well.
I did not cut holes for the bed tie down stakes but may go back and do that this evening.

 

[Tramguage1]

Welcome to the forum and the LE family.

 

[TripleB]

Not a big one, but an important one. Had some time to get my first accessory added last night.

I will be using the pioneer to work with my bee hives, the propolis from the boxes stick to everything and is very difficult if not impossible to remove. So I want to put some kind of mat in the bed.

I ordered a 4’ x 5’ x 1/8” Rubber cal diamond plate sheet rubber. Then just cut it with a utility knife and exacto knife to fit. Needs some time for the rubber to lay down since it was rolled up but fit turned out well.
I did not cut holes for the bed tie down stakes but may go back and do that this evening.
View attachment 203198View attachment 203197View attachment 203196

Is that your honey that they sell at the CO-OP in Clinton?

 

[Copnhgn]

Is that your honey that they sell at the CO-OP in Clinton?

No I don’t sell out of any stores, I just sell by word of mouth.

 

[TripleB]

I was

No I don’t sell out of any stores, I just sell by word of mouth.

Just wondering cause it says Andersonville on the bottle.

 

[Copnhgn]

Looking for some advise/suggestions from some folks that have installed a fuse block.
This area looked like a lot of dead space and would be out of the way, but now I’m wondering if it will be to inconvenient if I need to check something. The plate and the whole assembly can be pulled out with two screws as long as I leave the wiring long enough.

Still going to add a solenoid but haven’t received it yet, just couldn’t wait till I got it before I started. So the wire currently on the fuse box will be landed on the solenoid then a new wire will run from solenoid to fuse box.

 

[Dirtstiffs-1000]

Did you get your second battery under the plate?

 

[Copnhgn]

Did you get your second battery under the plate?

No, the battery would go in the compartment in front of it.