Radiator puke jug

[BigOL3]

Just wondering if everybody else jug is so for off center from the inspection hole. Even if my cables were not there, the cap can not be removed without pulling the whole jug forward, if adding fluid.

Sent from my SM-G965U using Tapatalk

 

[Hondasxs]

Mine is like that also.

Sent from my SM-G955U using Tapatalk

 

[BigOL3]

Mine is like that also.

Sent from my SM-G955U using Tapatalk

I was hoping someone knew a easy way to adjust it more to the center, other than pulling it forward and tying with wire.

 

[GlockMeister]

Mines off as well...has rubbed a spot through the camo...i tried tweaking the mount but not much movement. A guy could shim the mount out with a couple washers on the bottom hole a bit to bring it more to center

 

[BigOL3]

Mines off as well...has rubbed a spot through the camo...i tried tweaking the mount but not much movement. A guy could shim the mount out with a couple washers on the bottom hole a bit to bring it more to center

The best I could tell, it appeared to be mounted to the frame on the front side of jug. Kinda hard to tell without removing a bunch of plastic.

 

[GlockMeister]

The best I could tell, it appeared to be mounted to the frame on the front side of jug. Kinda hard to tell without removing a bunch of plastic.

Its a slotted wedge style mount..the jug is molded on one side to slide down into it. If you lift up on it you will.see what im talkimg about