I see that. Thea have some pretty long bolts. I’ll have to see when I get them on. They mentioned that in the package contents for the bead ring
Mine didn't I found out hard way and had to redo them cause they wouldn't torque .Before nut spacer it wasn't right
Did u add a bead sealer to that also before you seated them?
Nope been on there 8 months no problems added some cold weather air this fall
but I eventually got it with what I’d like to say was patience but it was laced with some profanity haha. @BWAF the beadlock bolts for these rims were long enough for the LT tires, that I was happy about lol. Back to it!
Looks good ! Glad too hear bolts were good. Forgot to tell you they suck to put on !Well...I got 2 of these buggers done so far. They look good, just a pin to get the bead to sit on the beadlock lip without the other side just popping up
Yes, a complete whore! Ha
Thanks, was bit of a back ache and I’m sure I’ll fell it tomorrow but it turned out good. First time I’ve mounted tires on Beadlocks. I’ve mounted plenty of z rateded low profile 22” Stage 2 mustang tires and there a treat, but the Beadlocks top that. It’s not real hard, just getting the bead to stay on the rim lip witch is only a 1/4 of the bead. There’s no real good way to do that easily. Those that have done Beadlocks know what I mean but I’m sure some rims/tires are easier than others. I used bead sealer on the back side beads.
Same problem I had that little lip with a big fatbead I found a big block holding rim up helped me keep tire down so could keep bead started
I just fought the hell out of it and called it a few choice words lol. I had about 3/4 of it on that at first used my thumbs to pop the rest on. Worked on the first one. The rest notnso much. I then used a small (smooth end) screwdriver to get underneath and use my thumb to hold the other side to keep it down. Was a bastard and a good way to combat stress lol
I soapped the hell out of them and still about crapped the amount of air I had to put in them to get back bead to pop out !
I soaped the bottom bead to get it on, went like butter. After the beadlock was tourqed, I used a bead sealer on the bottom bead and rim, I didn’t have to do anything to get it to sit. Just some air and POP! surprised the hell out of me! Don’t know if it was the rim, bead sealer or the quality of the tire. But I was happy to not have to fight that.
My rims have double bead on inside had to pop over one to get the actual inside bead I had to put almost 40 in them to pop it made rims ring
