P1000m5 Replacement front cup holders 1000-5

[swann549]

I like the black plastic cup holders better then the stainless ones because they are slightly bigger on the inside then the stainless steel ones and your mug will fit better.

Agreed @GPR1500SC Im looking to fit my yeti. I can barely get the can in the stocks, much less get it out without mauling it...

 

[GPR1500SC]

Agreed @GPR1500SC Im looking to fit my yeti. I can barely get the can in the stocks, much less get it out without mauling it...

This is what I was talking about.

www.ebay.com/itm/2PCS-Black-Plastic-Cup-Drink-Can-Holder-Universal-for-Car-Truck-Boat-Marine-RV/123702634370?hash=item1ccd406782:g:RM4AAOSwQXxclLw4

I had got the stainless steel one first and didn't like how tight they fit mugs like the yeti and replaced them with the plastic ones that look identical, but the plastic is a little thinner and work a lot better for me then the stainless ones did.

 

[swann549]

This is what I was talking about.

www.ebay.com/itm/2PCS-Black-Plastic-Cup-Drink-Can-Holder-Universal-for-Car-Truck-Boat-Marine-RV/123702634370?hash=item1ccd406782:g:RM4AAOSwQXxclLw4

I had got the stainless steel one first and didn't like how tight they fit mugs like the yeti and replaced them with the plastic ones that look identical, but the plastic is a little thinner and work a lot better for me then the stainless ones did.

Thanks for the info!!

 

[AZdonW]

I think I've found a solution better than the previous ones in this thread. I just finished installing these:

These are really two products from Amazon. One is a cup holder, about 3.45 inside diameter, and the other is an insert for a 3.5" Chevy Trailblazer cupholder.
Cup holder
Insert
Since the insert is a little bigger in diameter than the cupholder, I had to cut a wedge out of the insert to make it fit. It fits snugly, and does not come out with my rather large Bubba cup.
Here is the wedge: