P700 Squeaking Underneath

H

Hank---S

New Member
Jun 21, 2019
5
5
3
Georgia
Ownership

  1. 700-4
I have a 2019 Honda 700-4 that has a squeaking noise coming from somewhere underneath after the unit warms up. If I put it in 4wd it will stop. Most annoying sound ever!! Any suggestions? Still under warranty just didn't know if this may be something that was simple enough to keep me from going back to dealer.
 
JimmyA

JimmyA

Well-Known Member
Oct 8, 2017
1,644
5,504
113
Northeast texas
Ownership

  1. 700-4
I know that I can hear my rear brake rotor rub the brake pads most of time.
 
H

HondaTech

Guest
I use to get Ranchers that would squeak or squeal only when moving.

Ended up being the rubber boot on the driveshaft that was dry and rubbing the diff housing. I'm referring to the boots that have the o-rings holding them on.
 
Mudwing

Mudwing

Well-Known Member
Lifetime Member
Jul 9, 2017
36,959
306,672
113
The Mud holes
Ownership

  1. 700-4
You have to pin point it if it sounds that bad. There’ll be some new noises as it breaks in. Lift it off the ground and see if can duplicate the sound if you’re worried. My rear brakes squeak a bit but I ride her hard and put her away wet. I’m hitting 1200 miles and it’s pretty smooth. ;)
 
H

Hank---S

New Member
Jun 21, 2019
5
5
3
Georgia
Ownership

  1. 700-4
You have to pin point it if it sounds that bad. There’ll be some new noises as it breaks in. Lift it off the ground and see if can duplicate the sound if you’re worried. My rear brakes squeak a bit but I ride her hard and put her away wet. I’m hitting 1200 miles and it’s pretty smooth. ;)
It sounds like it is somewhere on the driveshaft towards the front. I guess I will carry it to the dealer and let them put it on the rack. Almost sounds like a bearing but can't understand why it stops at about 5mph. I will let y'all know what they find.
 
  • Like
Reactions: Mudwing
Diverguy

Diverguy

Well-Known Member
Oct 8, 2018
120
321
63
PA, USA
Ownership

  1. 700-4
I had the EXACT same thing on my '18...squeeked at low speed, stopped as soon as I engaged 4wd. I took it to the dealer...they drove it a bit, until it made the noise. First thing they asked- "was it in water". The tech sprayed a bunch of bushings, and it still squeeked. He said they could tear it down, but were 2 weeks out. It didn't sound mechanical to him, so we decided to let it go until Winter. It stopped completely the next weekend. But yes, it was very annoying.
 
  • Like
Reactions: Mudwing
Conner

Conner

Member
Jan 2, 2018
39
54
18
Michigan
Ownership

  1. 700-2
Loosen the 4 bolts that hold the front pinion and rotate it up with a 2x4 and tighten bolts. Mine stopped by doing this . I put on jacks started it up put in gear and just rest my finger on the front driveshaft and it would stop making the noise. Easy to try atleast takes 5min.
 
H

Hank---S

New Member
Jun 21, 2019
5
5
3
Georgia
Ownership

  1. 700-4
I use to get Ranchers that would squeak or squeal only when moving.

Ended up being the rubber boot on the driveshaft that was dry and rubbing the diff housing. I'm referring to the boots that have the o-rings holding them on.
Carried mine to the dealership first of the week and it was the boot where the drive shaft goes into the front differential. They greased it and all is good now. Squeak is completely gone thank God.
 
advertisement
Dave_H

Dave_H

Member
Sep 15, 2018
22
40
13
Michigan
Ownership

  1. 700-4

  2. 1000-5
Loosen the 4 bolts that hold the front pinion and rotate it up with a 2x4 and tighten bolts. Mine stopped by doing this . I put on jacks started it up put in gear and just rest my finger on the front driveshaft and it would stop making the noise. Easy to try atleast takes 5min.
Loosen the 4 bolts that hold the front pinion and rotate it up with a 2x4 and tighten bolts. Mine stopped by doing this . I put on jacks started it up put in gear and just rest my finger on the front driveshaft and it would stop making the noise. Easy to try atleast takes 5min.
 
  • Like
Reactions: Smitty335
Guitaraustin99

Guitaraustin99

Member
Feb 5, 2019
26
53
13
West Virginia
Ownership

  1. 700-2
I have a 2019 Honda 700-4 that has a squeaking noise coming from somewhere underneath after the unit warms up. If I put it in 4wd it will stop. Most annoying sound ever!! Any suggestions? Still under warranty just didn't know if this may be something that was simple enough to keep me from going back to dealer.

Check the clamps on the heat shield. Mine have loosened up a few times and make a "chirping/squeaking".
 
  • Like
Reactions: Smitty335
JimmyA

JimmyA

Well-Known Member
Oct 8, 2017
1,644
5,504
113
Northeast texas
Ownership

  1. 700-4
Carried mine to the dealership first of the week and it was the boot where the drive shaft goes into the front differential. They greased it and all is good now. Squeak is completely gone thank God.
Good to know! Thanks for posting.
 
  • Like
Reactions: Smitty335
H

HondaTech

Guest
Carried mine to the dealership first of the week and it was the boot where the drive shaft goes into the front differential. They greased it and all is good now. Squeak is completely gone thank God.

We got a service article about this noise, and this was one of the fixes.

Could also be the nub at the front shaft being dry as well.
 
  • Like
Reactions: Smitty335
jmanAZ

jmanAZ

Member
Jan 14, 2020
57
50
18
tucson
Ownership

  1. 700-4
We got a service article about this noise, and this was one of the fixes.

Could also be the nub at the front shaft being dry as well.
hi,

mine is making this noise and since I'm under warranty I'm taking mine in Monday. I told my dealer there was a service bulletin and they said they hadn't heard of it. How can I find the bulletin?
 
  • Like
Reactions: Smitty335
H

HondaTech

Guest
hi,

mine is making this noise and since I'm under warranty I'm taking mine in Monday. I told my dealer there was a service bulletin and they said they hadn't heard of it. How can I find the bulletin?

Refer them to the April,May,June "The Wrench" quarterly news letter we get. Ive attached a picture of the article.

Screenshot 20200925 213904 Drive
 
B

Bassmf

New Member
May 7, 2021
2
2
3
Texas
Ownership

  1. 700-4
Loosen the 4 bolts that hold the front pinion and rotate it up with a 2x4 and tighten bolts. Mine stopped by doing this . I put on jacks started it up put in gear and just rest my finger on the front driveshaft and it would stop making the noise. Easy to try atleast takes 5min.
What 4 bolts exactly I have the same issue!
 
advertisement

About us

  • Our community has been around for many years and pride ourselves on offering unbiased, critical discussion among people of all different backgrounds. We are working every day to make sure our community is one of the best.

User Menu

Buy us a beer!

  • Lots of time and money has gone into making sure the community is running the best software, best designs, and all the other bells and whistles. Care to buy us a beer? We'd really appreciate it!

    Beer Fund!

    Club Membership!