18” light bar on stock X4 bumper

[SpeedBuggy]

This is on the Honda bumper not the stock hoop but could be a solution for not adding length. I used a piece of flat aluminum bar and drilled to fit a couple 3” pod spots lights. As you can see mine are high quality chineseium alloy but they will swap for higher end rigid or Baja designs if desired. The spots put the beam out further than the stock lights. I am running the amber color as it seems to cut through the dust better.

 

[Admin]

 

[SpeedBuggy]

Also have these mounted higher.

 

[Montecresto]

Also have these mounted higher. View attachment 220730

Dang dude, you’re the guy nobody wants behind them on the trail at night.....

Presumably they are on dedicated switches. I like the top one but I’ve had to slide under so many low hanging branches on the trail That I’m afraid to mount one up there unfortunately and I tried just under the lip, but I’m tall and my visibility out the top of the windshield is already diminished on the Talon compared to the Pioneer.

I also like your low pods out front above the winch.

 

[SpeedBuggy]

Dang dude, you’re the guy nobody wants behind them on the trail at night.....

Presumably they are on dedicated switches. I like the top one but I’ve had to slide under so many low hanging branches on the trail That I’m afraid to mount one up there unfortunately and I tried just under the lip, but I’m tall and my visibility out the top of the windshield is already diminished on the Talon compared to the Pioneer.

I also like your low pods out front above the winch.

Haha, it puts out the light for sure. We have some low stuff too, mostly overgrown brush and the paint is starting to wear off on the eleading edges. It is below the lip of the roof so that helps. Yes, separate switches. I also broke apart the wiring harnesses to isolate the relay from the switch. Relay to direct power and switch to key power. This keeps from running the relay amperage through my keyed power fuse on the XTC buss bar

 

[Montecresto]

Haha, it puts out the light for sure. We have some low stuff too, mostly overgrown brush and the paint is starting to wear off on the eleading edges. It is below the lip of the roof so that helps. Yes, separate switches. I also broke apart the wiring harnesses to isolate the relay from the switch. Relay to direct power and switch to key power. This keeps from running the relay amperage through my keyed power fuse on the XTC buss bar

Oh I couldn’t see that yours was under the lip. That’s good protection.

Im doing the same thing with relation to the keyed power, relay and switches.... that seems the best protection.....

 

[Montecresto]

Also have these mounted higher. View attachment 220730

Btw, what kind of a storage facility is your Talon setting in there?

 

[SpeedBuggy]

3rd car garage.