P1000 Red Baron

[Tigermark]

You top picture - either that is an optical illusion, I have gotten into @Smitty335 stash but I don’t remember a slit like that on mine- is that a new design

Ok, that slit allows you to access the ports in the coolant lines.

 

[Tigermark]

Ok, that slit allows you to access the ports in the coolant lines.

 

[Ragnar406]

What is with the part circled? Looks like it is cut out or someway you have rigged to hold up

 

[Smitty335]

What is with the part circled? Looks like it is cut out or someway you have rigged to hold up
View attachment 75983

Yea that?

 

[Tigermark]

What is with the part circled? Looks like it is cut out or someway you have rigged to hold up
View attachment 75983

Oh , that’s just the strap on the winch cable hanging down in the picture

 

[Ragnar406]

Oh , that’s just the strap on the winch cable hanging down in the picture

Now I feel dumb

 

[Tigermark]

@Ragnar406 , better?

 

[Tigermark]

Now I feel dumb

Oh no, your observant!

 

[Smitty335]

Now I feel dumb

We feel your pain, HA!

 

[popeye]

View attachment 75944

Helpful advice of the day from ol Tiger. Safety is very important, always wear your safety shoes!

That’s a crock of $h!t


Sent from my iPhone using Tapatalk

 

[Tigermark]

Ok, once you have reused the factory hardware holding the pieces in place, take a break and check the forum and have a beer.

 

[Tigermark]

Now the fun part. Installing the supplied hardware. Thirty-two screws to go. Remember, the screws on the nerf bars get no washers.

 

[Tigermark]

The supplied screws are self tappers, however many of the are going into round tubing. Pre- drill a pilot hole if your struggling. *** use your safety glasses ***

 

[Plumber32]

View attachment 75993

The supplied screws are self tappers, however many of the are going into round tubing. Pre- drill a pilot hole if your struggling. *** use your safety glasses ***

I put pipe dope with Teflon on the screws so I can get them unscrewed again and not break

 

[Smitty335]

View attachment 75993

The supplied screws are self tappers, however many of the are going into round tubing. Pre- drill a pilot hole if your struggling. *** use your safety glasses ***

I just used a punch to make an indentation, I'm lazy!

 

[Smitty335]

I put pipe dope with Teflon on the screws so I can get them unscrewed again and not break

Dang leave it up to a plumber, did you do an air test?

 

[Plumber32]

Dang leave it up to a plumber, did you do an air test?

Told the inspector I did!

 

[GlockMeister]

Lookin good buddy! But your footwear really concerns me

 

[elkguide]

Lookin good buddy! But your footwear really concerns me

Remember, he's a "LEFT coaster" now.

 

[Tigermark]

A few unique items!