R
rickoshea
Guest
right?? if i take even one hand off the wheel i'm in a world of trouble. 😄 😄You relax while riding? I may need some lessons! HA!
right?? if i take even one hand off the wheel i'm in a world of trouble. 😄 😄You relax while riding? I may need some lessons! HA!
Rickoshea, you put Razor buckets in your P1K5? How much truble was thtat and how when do they work?i use a red/black hilti tool bag.works perfect,but i pulled the bench and installed bucket seats so i have a lot of room between the seats.View attachment 197096
i had a couple sheets of 1/2" lexan,so i traced the oem bench on it and cut it to fit like the original bench,drilled some holes thru it and sunk some rivnuts into the frame and put boom mat on the bottom and rubber mat on the top and at the back where the back of the seat bolts to the rops.i just need to cut a hole to access the sub trans dipstick,plan to install a 4" round boat deck hatch to get to it in the future without having to remove the bolts that hold the base down.the seats sit up high but i get a good sight line.i wasn't sure i could get used to the new seating position but i like it more every time i ride.the seats are comfortable and were very inexpensive.when i come across a set of talon seats i'll swap them out.i can switch back to the bench seat by undoing 6 bolts.takes about 3 mins to swap back and forth.Rickoshea, you put Razor buckets in your P1K5? How much truble was thtat and how when do they work?
How much higher is that set-up than the bench seat?i had a couple sheets of 1/2" lexan,so i traced the oem bench on it and cut it to fit like the original bench,drilled some holes thru it and sunk some rivnuts into the frame and put boom mat on the bottom and rubber mat on the top and at the back where the back of the seat bolts to the rops.i just need to cut a hole to access the sub trans dipstick,plan to install a 4" round boat deck hatch to get to it in the future without having to remove the bolts that hold the base down.the seats sit up high but i get a good sight line.i wasn't sure i could get used to the new seating position but i like it more every time i ride.the seats are comfortable and were very inexpensive.when i come across a set of talon seats i'll swap them out.i can switch back to the bench seat by undoing 6 bolts.takes about 3 mins to swap back and forth.