![Bad_bowtie](/data/avatars/m/5/5077.jpg?1613324150)
Bad_bowtie
Huge member
Lifetime Member
Aluminum skid off, gotta take a screwdriver to the frame tommorow when I have some light to clean the mud out of all the nooks and crannies. Already a couple hundred pounds lighter I bet.
Aluminum skid off, gotta take a screwdriver to the frame tommorow when I have some light to clean the mud out of all the nooks and crannies. Already a couple hundred pounds lighter I bet.
View attachment 197563
Trail Armor skids are on, but definitely gonna have to trim up the area in the front wheel well.
View attachment 198078View attachment 198079
View attachment 198085
I'm running 28 inch evos with no arms and I was rubbing at full cock on my skids. I heated with propane torch and bent them up and fixed it. Now I'm rubbing the spot in the white circle at full compression. I wish I would have kept those superatv arms now. Lol
My buddy had to do the same with the 28's before we rode RRB last yearTrail Armor skids are on, but definitely gonna have to trim up the area in the front wheel well.
View attachment 198078View attachment 198079
Sweet!!!Havent updated anything in a while ,but I recently added Fox shocks all the way around and today I finally put on @jak9922 's stainless brake lines. They seemed to help the pedal feel a little and they seem to stop better if you have to get on the brakes hard. But most importantly they wont be as easily pinched/cut as the factory soft lines.
View attachment 229207View attachment 229208
Sweet!!!
Are they the same that come on the LE's?
That’s awesome! Whatcha think?
One more thing added to my list. Thanks 😂Definatly an improvement. Especially with our upcoming Windrock trip, I wont have to worry about the brake lines anymore.
🤔 them fox shocks will definitely add to the resale value come November 😉One more thing added to my list. Thanks 😂
Is that the Honda oem under dash storage?I got a couple new add ons for Christmas. The wife got me the underdash storage and the WFO windshield extender. Really liking both so far.
View attachment 172494 View attachment 172497
I don’t think his is the oem one but it works just as well. I’ve ridden in his pioneer a few times and it seems to be as good of quality as the Honda one.Is that the Honda oem under dash storage?
Yup, as usual, your right. Not the oem one but works just the same.I don’t think his is the oem one but it works just as well. I’ve ridden in his pioneer a few times and it seems to be as good of quality as the Honda one.
In the last few years I have switched to using Kopr-Shield from Thomas & Betts on all my electrical connections for my marine, automotive and RV wiring jobs. It improves the electrical conductivity and eliminates the corrosion from moisture. It is messy, so I "acquired" eyelash brushes from my wife's supplies to use to apply it. It only takes a little bit to be effective. Don't just plaster it on and get it all over because it is conductive. I got tired of all the silicone contamination on everything from the Dielectric compound.Just a word of advice.. I would put dielectric grease on all the connectors and connections as there’s so much moisture, crud and corrosion over time. It’ll save you aggravation down the road and it’s easy to do now while everthing is clean and fresh.
You’ll like garage products bushingsHaven't posted any updates in a long while, really no major updates done, but time for some much needed maintenance. I had a rear axle boot torn, so I replaced the axle with Rhino 2.0. The plan is to change the boot and have a spare rear axle. Also the front end has became very loose at highway speeds and very squeaky just working the steering wheel. After jacking up the front end it was very obvious the A Arm bushings are toast. I installed @RB3offroad bushings when I installed the @SuperATV A arms in November 2019. After about 1500 miles they are shot. So for now I put my original super atv bushings in. Just contacted Garage Products for a set of their bushings to replace all 4 corners with. I've heard nothing but rave reviews on the Garage Products bushings.
View attachment 281345 View attachment 281346 View attachment 281347 View attachment 281348 View attachment 281349 View attachment 281350