P1000 Injection issues

[Flemz84]

Good day all I have an injection issue as when I turn my machine on the injection on one cylinder runs flat out for awhile anyone had this issue before? I had the same issue as previous people have had like running rough and very fueley on one cylinder and if swap cylinders it follows. Have tried all the suggestions in previous posts and have found nothing but the injection issue
regards Ryan
Ps thanks for all the help

 

[Admin]

 

[Flemz84]

Also has engine light flashing 9x

 

[NTCPrezJB]

Also has engine light flashing 9x

Should be a combo of long and short flashes. Count them and post it or record it, upload to YouTube and post the link to it here.

have you replaced the injector wires? Site store sells a pigtail. But usually that solution is for a lack of fuel I think.

 

[Flemz84]

Should be a combo of long and short flashes. Count them and post it or record it, upload to YouTube and post the link to it here.

have you replaced the injector wires? Site store sells a pigtail. But usually that solution is for a lack of fuel I think.

Ok as I’m Aussie I will do that tomorrow and post it. I did make my own pig tail and try them and it was still the same I’m beat the only thing I can think of is the ecu not responding

 

[NTCPrezJB]

Ok as I’m Aussie I will do that tomorrow and post it. I did make my own pig tail and try them and it was still the same I’m beat the only thing I can think of is the ecu not responding

Any wire damage near the ecu?

 

[Ericthered]

Can you wash it? Dirty connectors will make this old girl a real b****.

 

[P1K5Dave]

Not sure if the injector plug/wires are your problem either, just wanted to add that when mine went bad you couldn't really tell by inspection. Wires were still intact and seemed OK (where other guys have had wires pulling out and such.)

Replacing them fixed it.

Regarding your blinks, as mentioned before parse out long vs. short blinks. An injector circuit code would be two long and either 1 or 3 short blinks (21 or 23)