G
That looks sweet ,I like it !!!Got new bed extender today. 15 min install and it was on! Dirt road really does a nice job. 32 in tensor regulator fit in the bed but barely. I was hoping that would be the case because I wanted to keep the spare down as low as possible.View attachment 193475View attachment 193472View attachment 193473 View attachment 193474
I’m not sure where ur talking about in the measurement but lm planning on mounting a rotopax gas jug off the left roll bar and a rotopax water jug off the right one. The measurement to the bends in the end gate is 20 inches to the start of the bend. I might mount my 2 jugs off the back of end gate but was concerned about adding more length.Sweet!! I've been looking at those, one of my last add-ons. Could you measure the straight section across the width, plz? I want to mount a 21.25" wide Rotopax across the inside and need to know if it'll fit without running into the corner bends.
Sweet!! I've been looking at those, one of my last add-ons. Could you measure the straight section across the width, plz? I want to mount a 21.25" wide Rotopax across the inside and need to know if it'll fit without running into the corner bends.
20" inside the end gate bends is what I needed to know, thanks. 👍I’m not sure where ur talking about in the measurement but lm planning on mounting a rotopax gas jug off the left roll bar and a rotopax water jug off the right one. The measurement to the bends in the end gate is 20 inches to the start of the bend. I might mount my 2 jugs off the back of end gate but was concerned about adding more length.
I love mine, 6k miles without a problem.Just ordered one of these today with a 14-week lead time. Can't wait!
Steve
Thank you sir for your business and patience.Just ordered one of these today with a 14-week lead time. Can't wait!
Steve
Yes it will work with the front or rear wheel in either high or low mount position.Will the low spare tire mount work with a 6+1 offset (front) wheel?
I think you're SOL. You could always sell the HMF and add a Dragonfire hitch.I think I'm finally ready to pull the trigger. I'm still concerned with making it work with my HMF bumper. If anyone has done it please post a picture. I want one bad but i don't want to lose my bumper with the built in hitch.
View attachment 316273
I have sent pieces to adapt my extender to the HMF bumper but I don't have a Talon or the HMF bumper to do it myself.I know he makes brackets to mount to the honda bumpers. hoping someone had made them work with other bumpers.
Thank you.Order placed